Microsoft, Windows, and Windows Vista are either. Unless specified in this service manual, lubrication of contacts is not required. Switching to user s mode If turn-off and turn-on then switched to user s mode. Hz ne support screen is displayed when the applied frequency is under or over factory preset timings. Out of Range screen is displayed when the applied frequency is under or over normal range.
|Date Added:||28 March 2017|
|File Size:||64.53 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Always remove the test instrument ground lead last.
Is the output of Scaler correct? Remove the defective transistor by clipping its leads as close as possible to the component body.
The matrix employs asi Thin Film Transistor as the active element. Do not use freon-propelled spray-on cleaners. Connecting Monitor Cables 5.
DAEWOO LUCOMS CO LTD, NWGQ.E – UL Product Spec
Microsoft, Windows, and Windows Vista are either trademarks or registered. Be certain to remove all foreign materials. See the label attached on. Replace the main board or replace Scaler. These can generate enough electrical charges to damage ES devices. In this lab, you will create the power supply that transforms the AC wall.
Service Manual LCD COLOR MONITOR. Model : CML-710 DAEWOO LUCOMS CO., LTD.
Suited for inductive loads. Trouble in Scaler U6. Symbols in the manual The symbols indicate where applicable cautionary or other information is to be found.
Set the contrast up to Max. And so, this TFT LCD monitor has a maximum horizontal resolution of dots and a maximum vertical resolution of lines for superior clarity of display. All Rights Reserved Even though the K3 s audio output.
Minimize bodily movements when handling unpackaged replacement ES devices. Read, understand and follow Safety Rules and Operating Instructions in this manual before using this product. Telephone Fax Technical Support Hours: Draw away the melted solder with an anti-static suction-type solder removal device or with desoldering braid before removing the IC. After removing the electrical assembly equipped with ES devices, place the assembly on a conductive surface such as aluminum foil to prevent electrostatic charge buildup or exposure to the assembly.
Most replacement ES devices are packaged with leads electrically shorted together by conductive foam, aluminum foil, or comparable conductive material. Soldering must be inspected for possible cold solder points, frayed leads, damaged insulation, solder splashes or sharp solder points.
RGB sync on green is through Scart connection More information.
Always connect the test instrument ground lead to the appropriate instrument chassis ground before connecting the test instrument positive lead. Audra Griffith 1 years ago Views: Excellent value More information. Carefully remove the device from the circuit board. Remove defective diode by clipping its leads as close as possible to diode body.
Start display at page:. Allow 20 minutes warm-up time for the display before checking or adjusting daeewoo electrical specification or function. Is the input signal normal? Used for the easy More information. Service work should be performed only after you are thoroughly familiar with all of the following safety checks and servicing guidelines.